Antari DNG-100 Universal Fog Cooler with DMX

The DNG-100 converts normal fog from fog machine into a floor-hugging cloud which is almost virtually similar to the dry ice effect. This is achieved by cooling the temperature of the fog to the point where it falls to the ground. The DNG-100 is easy to operate as there are no external controls on the machine. Simply plug the unit in and place the fog conducting hose from the output of any fog machine to the input of the DNG-100. The unit is fully operational upon being plugged in. Note that the volume of fog produced is controlled by the fog machine that the DNG-100 is attached to. For best low fog effect, use Antari FLR or FLC Fog Fluid.

Antari DNG-100 Universal Fog Cooler Features:

• Ideal operating temperature is 10 - 30 degrees Celsius.
• After moving or transporting this unit, wait five minutes before operating.
• Input fog must be clean. Contaminated fog may damage internal parts.
• There must be a free air space of at least 15 cm (6 inches) between the fog cooler intake and the fog machine output.
• After interrupting operation, wait three minutes before starting again.
• Keep this device dry. For inside use only. Not designed for outside use.
• Keep fog cooler upright. Do not tilt this device. Angle of inclination may not exceed 10 degrees.
• Turn off or unplug when not in use.
• This machine is not water-proof. If moisture, water, or fog liquid gets inside the housing, immediately unplug the unit.
• Locate the fog cooler in a well-ventilated area. Never cover the unit’s vents. The fog cooler is best installed 1 meter away from all objects.
• Use only ANTARI FLR Fog Liquid.